RAM 4.5 BUX II Series Manual de usuario descargar pdf (Pagina 7)

DE1 User Manual

The following hardware is provided on the DE1 board:

• Altera Cyclone

II 2C20 FPGA device

• Altera Serial Configuration device – EPCS4

• USB Blaster (on board) for programming and user API control; both JTAG and Active Serial

(AS) programming modes are supported

• 512-Kbyte SRAM

• 8-Mbyte SDRAM

• 4-Mbyte Flash memory

• SD Card socket

• 4 pushbutton switches

• 10 toggle switches

• 10 red user LEDs

• 8 reen user LEDs

• 50-MHz oscillator, 27-MHz oscillator and 24-MHz oscillator for clock sources

• 24-bit CD-quality audio CODEC with line-in, line-out, and microphone-in jacks

• VGA DAC (4-bit resistor network) with VGA-out connector

• RS-232 transceiver and 9-pin connector

• PS/2 mouse/keyboard connector

• Two 40-pin Expansion Headers with resistor protection

• Powered by either a 7.5V DC adapter or a USB cable

In addition to these hardware features, the DE1 board has software support for standard I/O

interfaces and a control panel facility for accessing various components. Also, software is provided

for a number of demonstrations that illustrate the advanced capabilities of the DE1 board.

In order to use the DE1 board, the user has to be familiar with the Quartus II software. The

necessary knowledge can be acquired by reading the tutorials Getting Started with Altera’s DE1

Board and Quartus II Introduction (which exists in three versions based on the design entry method

used, namely Verilog, VHDL or schematic entry). These tutorials are provided in the directory

DE1_tutorials on the DE1 System CD-ROM that accompanies the DE1 board and can also be

found on Altera’s DE1 web pages.

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

Sin comentarios

RAM 4.5 BUX II Series Manual de usuario Pagina 7