RAM 1.6 Manual de usuario

Copyright 2014 - 6th Element Engineering, LLC HYUNDAI VELOSTER SHORT RAM 1.6T INTAKE INSTALLATION INSTRUCTIONS Installation: Tools needed

Copyright 2014 - 6th Element Engineering, LLC 15. Use the small flat head to remove the plastic push lock fasteners from the top of the snorkel, the

Copyright 2014 - 6th Element Engineering, LLC 17. Next, install the intake pipe as shown. The bung for mounting should be closest to you. Then att

Copyright 2014 - 6th Element Engineering, LLC 19. Next, install the mounting bracket and secure with the small M6 flange nut. 20. Lastly, we conne

Copyright 2014 - 6th Element Engineering, LLC 21. Install your bumper and splash shields, plug in your fog lights, hook the battery back up, and th

Copyright 2014 - 6th Element Engineering, LLC 1. Disconnect the negative battery cable from the battery. This nut is 10mm. 2. Raise the front of

Copyright 2014 - 6th Element Engineering, LLC 4. Remove the top half of the stock air box. There is a clip on the right and in the front. Then lo

Copyright 2014 - 6th Element Engineering, LLC 6. There are 3-10mm screws securing the bottom half of the air box. Two on the right, and one on the

Copyright 2014 - 6th Element Engineering, LLC 8. Next, the front bumper needs to be removed. Start by removing the 10mm screws holding the bumper

Copyright 2014 - 6th Element Engineering, LLC 10. Next, we need to remove the screws on the bottom of the bumper using the screw drivers. There are

Copyright 2014 - 6th Element Engineering, LLC 11. After the bumper screws are out, unplug the fog lights (if equipped) before you pull the bumper.

Copyright 2014 - 6th Element Engineering, LLC 13. To remove the bumper, grab the fender and front grill as shown. Pull towards the front of the car

Copyright 2014 - 6th Element Engineering, LLC 14. After the bumper is removed, the lower factory air box and intake snorkel must be removed. There